Ignoring Blocks of Zeros

Normally, tar stops reading when it encounters a block of zeros between file entries (which usually indicates the end of the archive). --ignore-zeros (-i) allows tar to completely read an archive which contains a block of zeros before the end (i.e. a damaged archive, or one which was created by cat-ing several archives together).

The --ignore-zeros (-i) option is turned off by default because many versions of tar write garbage after the end-of-archive entry, since that part of the media is never supposed to be read. GNU tar does not write after the end of an archive, but seeks to maintain compatablity among archiving utilities.

--ignore-zeros

-i

To ignore blocks of zeros (ie. end-of-archive entries) which may be encountered while reading an archive. Use in conjunction with --extract (--get, -x) or --list (-t).

Go to the first, previous, next, last section, table of contents.